EPA Proposes Updates to Air Regulations for Oil and Gas Industry

August 31, 2019

 

The updates to air regulations intend to remove redundant requirements and reduce compliance burdens where environmentally appropriate.

The U.S. Environmental Protection Agency (EPA) proposed updates to the oil and natural gas industry national standards. The proposal intends to remove regulatory duplication while maintaining health and environmental regulations on oil and gas sources that the agency considers appropriate. The proposal is the result of EPA’s review of the 2016 New Source Performance Standards (NSPS) for the oil and natural gas (O&G) industry conducted in response to Executive Order 13783 – Promoting Energy Independence and Economic Growth. The goal was to review existing regulations that could potentially “burden the development or use of domestically produced energy resources,” including oil and natural gas.

The resulting regulatory impact analysis from EPA estimates that the proposed amendments could save the O&G industry $17-$19 million a year, for a total of $97-$123 million from 2019 through 2025.

“EPA’s proposal delivers on President Trump’s executive order and removes unnecessary and duplicative regulatory burdens from the oil and gas industry,” said EPA Administrator Andrew Wheeler. “The Trump Administration recognizes that methane is valuable, and the industry has an incentive to minimize leaks and maximize its use. Since 1990, natural gas production in the United States has almost doubled while methane emissions across the natural gas industry have fallen by nearly 15%. Our regulations should not stifle this innovation and progress.”

In its primary proposal, the agency is proposing to remove sources in the transmission and storage segment of the O&G industry from regulation. These sources include transmission compressor stations, pneumatic controllers, and underground storage vessels. The agency is proposing that the addition of these sources to the 2016 rule was not appropriate, noting that the agency did not make a separate finding to determine that the emissions from the transmission and storage segment of the industry cause or significantly contribute to air pollution that may endanger public health or welfare.

The primary proposal also would rescind emissions limits for methane, from the production and processing segments of the industry; keeping emissions limits for ozone-forming volatile organic compounds (VOCs). These sources include well completions, pneumatic pumps, pneumatic controllers, gathering and boosting compressors, natural gas processing plants and storage tanks. The controls to reduce VOCs emissions also reduce methane at the same time, so separate methane limitations for that segment of the industry are redundant.

In an alternative proposal, EPA would rescind the methane emissions limitations without removing from regulation any sources from the transmission and storage segment of the industry.

The agency also is seeking comment on alternative interpretations of EPA’s legal authority to regulate pollutants under section 111(b)(1)(A) of the Clean Air Act.

This proposal is in addition to a September 2018 technical action that proposed targeted improvements to help streamline implementation, reduce duplication of EPA and state requirements, and significantly decrease unnecessary burdens on domestic energy producers. EPA is currently reviewing comments received on that technical package and expects to issue a final rule in the upcoming months.

EPA will take comment on the proposal for 60 days after its publication in the Federal Register, and will hold a public hearing. EPA will announce details of the hearing shortly.

More information, including a pre-publication version of the Federal Register notice and a fact sheet, is available at https://www.epa.gov/controlling-air-pollution-oil-and-natural-gas-industry

Link to the proposal: https://www.epa.gov/sites/production/files/2019-08/documents/frn_oil_and_gas_review_2060-at90_nprm_20190828revised_d.pdf

Link to fact sheet: 

 

Air Monitoring at SCS Engineers / O&G Services

 

 

 

 

Posted by Diane Samuels at 6:00 am